Rayla
Pharmaceutical machinery experts

Inflatable Seals

The inflatable seals supplied by Rayla are designed to provide a clean, time saving solution to hermetic sealing against, powders, granules, gases, liquids and dust.

    • These seals are most useful to seal fabricated pieces of equipment where:
    • the sealing gap may vary fast efficient assembly and disassembly is required
    • hygienic procedures exist (FDA applications)

Generally working from within a given groove size the seals can operate axially, radially inward or radially outward.

Rayla Inflatable Seal

All seals are supplied with a suitable inflation connector, selected to accommodate any restrictions associated with the equipment or customer preference.

Rayla Inflatable Seal

Most requirements are for the FDA approved Silicone Rubber in either white or red iron oxide colours. Other rubbers and colours are available. Using pre-extruded profiles held in stock, the manufacturers utilise a high pressure ‘Shot Moulding technique, which injects an identical compound at the join forming a high strength bond, with a clean smooth line finish. No additives or adhesives form part of the bond. This process provides the seal with an ability to work under higher pressures than most if not all other similar type seals in the market.

The same ‘Shot Moulding’ technique is used to bond most types of inflation connectors to the seals. This procedure bonds the connector to the parent seal during the vulcanisation of the injected compound, the strength of which far exceeds any mechanical fixing or adhesive bond, associated with this type of seal.

All seals are independently pressure tested and supplied with a supporting ‘Test Certificate’. These tests on free standing, unsupported seals vary from 1 bar to 4 bar pressure, dependent on the profile type and/or customer specification.
With the aid of purpose designed test rigs, which enclose the seal, our production techniques are tested (and supported with proven case history) on some profiles to perform at up to 12 bar pressure.

The profiles shown are the most frequent extrusions utilised in the manufacture of FDA approved silicone rubber inflatable seals. Other profiles are available and others can be manufactured to virtually any customer design or requirement.

The inflated dimensions shown are guides only, as unsupported surface area (closure dimension), can restrict working pressures on some seal profiles. Customers should verify specific profile suitability with our
technical sales department.